Electric actuators

Susin I-Tork spring return electric actuators for ball, butterfly and plug valves that must go to a safe position when the power fails. 4 models from 50 to 300 Nm; an independent spiral spring returns the valve in 1.8 seconds.
Sizes
Four models in two body sizes, with the ISO 5211 flange on the left. Motor and spring torque are the same; each row opens the model in the table.

What’s different
Susin I-Tork’s QS uses an independent spring structure, held by a magnetic brake, rather than a spring the motor has to drive every stroke.
FAQ
The magnetic brake releases and the independent spiral spring turns the valve to its safe position in 1.8 seconds (2, 3 or 4 seconds as options). In normal running the motor drives only the reducer, not the spring.
Take the valve’s highest torque, add a safety factor, and pick the smallest QS that covers it. Motor and spring torque are the same on every model, so the valve gets the same torque on the spring stroke. Then check the ISO 5211 flange: F07 on QS05 and QS10, F10 / F12 on QS20 and QS30.
AC 110, 220, 380 or 440 V, or 24 VDC.
Yes. It runs on/off (S2, 30 min) or modulating (S4, 50%) with a 4–20 mA control signal, or 0–10, 0–5, 1–5 or 2–10 VDC as options. Susin I-Tork notes that the ITQ series options are also available on the QS.
No. The QS is IP67 (IP68 option) but is not available explosion proof; Susin I-Tork lists it as under development. For a hazardous area, the ITQ series has an explosion proof option.
Both move the valve to a set position on power loss. The QS does it with a spring, from 50 to 300 Nm. The ITQ’s BP battery backup option does it with a rechargeable battery, on 1 phase ITQ 0160 to ITQ 0500.
Compare all 4 QS models by torque, time and flange, or send us the valve torque, power supply and safe position and we’ll pick the model.